Vitek VT-H41 Guía de usuario descargar pdf (Pagina 14)

VT-H41



Table 1.2 Rear Panel Connections

1-3-2. Network connections

 LAN Connection – Using the cross cable, without a switching hub

Connect to the system directly, using a cross type network cable

 LAN Connection – Using a switching hub

Connect to the system, using a hub (Switching hub) and an Ethernet cable (10BASE-

T/100BASE-TX CAT 5 LAN cable)

VIDEO IN Four connectors for video input. Connect camera cable to Video-in (NTSC/PAL)

VIDEO OUT Composite video output in NTSC or PAL format. Connect to Composite Monitor.

VGA Connector for VGA monitor

RS-232 For engineering use only

SENSOR IN

Connector for sensor device. 4 sensors can be connected to the system. Sensor 1, 2, 3, 4

are dedicated to Video channel 1, 2, 3, 4, respectively. Either normally open (NO) or normally

closed (NC) sensor can be selected. Simple On/Off switching.

Connect two signal lines of sensor (infrared rays sensor, heat perception sensor, magnetic

sensor) to the desired sensor number. (You can set the type-NC or NO- of sensor at “Setup”

mode).

NOTICE

SENSOR inputs require dry contact only. Do not input any electric signal.

ALARM OUT

Connector for alarm device connection.

Provides simple On/Off switching using relay. 0.5A/125V, 1A/30V

LAN RJ45 connector for LAN connection

DC 12V Apply 12V DC using the DC adaptor supplied with the equipment.

SWITCHES

Select VGA monitor or CVBS (Composite Video Blanking Sync) monitor.

Do not change the setting when the power is on.

When the position of the switch is changed, the DVR should be rebooted to apply the new

setting.

Cross type cable

IP Router or HUB



1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Sin comentarios

Vitek VT-H41 Guía de usuario Pagina 14